Looking for a floor makeover for your home today, try out the USA cork flooring. Steps to consider while cork flooring
• When applying the water-based polyurethane on a just finished cork floor ensures that you are equipped with the right applicator. Look for a micro-fiber low nap painter’s roller. One should then work quickly on applying the polyurethane to avoid occurrences of short working edges. If lap marks appear, you should stop applying as its either you were too slow or the layer you had applied was too thin. Make sure that the roller has been saturated with the cork flooring polyurethane, and any extra should be squeezed out to avoid a scenario where it is dripping. While working with rollers rolls it in one direction beginning from one edge to the other. It is crucial to note that one only has roughly 10-15 minutes so go back to their starting point. So they must be quick to ensure that the floor has been covered completely.
• Be patient enough for the entire floor to dry. In case some lap marks appeared one should lightly sand them off. This has been proven to be the best way of getting rid of these marks. Then you should add a second cork flooring polyurethane layer. In the case of the glue down cork tiles, they should have to rest for about 24 hours before the final finishing is applied.
• On the other hand, when it comes to a floating cork floor, it is finished only after the floor has been installed. Professionals usually allow this floating floor to settle for a couple of days before their finishing layer is applied. The advantage here is that this flooring will not be capable of contracting and expanding after its sealant is applied. This period of rest proves to be necessary as it is here that any potential errors committed are identified and rectified accordingly.
In the case that one’s floor seems to be buckling around its plank edges it is not advisable for us to apply the polyurethane. Such problems when they manifestly are good indicator or warnings that the flooring was not laid properly. If you go ahead while ignoring those indicators, the problem will only persist.
How to Prepare the Floor
Thoroughly sweep the floor surface. If possible use a vacuum cleaner to try as much as possible to remove the sand and grit. Then follow up with a cloth which has been dampened with water before allowing the floor to dry.
There are several methods of USA cork flooring curing. One of these methods is the direct pour method. It is mostly used by the professional layers who have been able to do several floors.
Article Source: https://www.bharatbhasha.com
Article Url: https://www.bharatbhasha.com/home_improvement.php/486502
Article Added on Wednesday, December 17, 2014
|home improvement >> Top 50 Articles on Home Improvement|
|Category - >|